Gaahleri Aventus Verdant Ember Airbrush — 0.2 & 0.4 mm Dual Action (SKU: [INSERT SKU])

Ace Series · gravity feed · CNC-milled aluminium body · patent-pending Vortex Nozzle System

Why this airbrush

✓  Two airbrushes in one box. A 0.2 mm setup for ultra-fine detail and a 0.4 mm setup for basecoats, priming and coverage — swap the nozzle setup instead of swapping brushes.

✓  CNC-milled aluminium body. Cut from a single block with no weld lines — balanced, light in the hand and built to last.

✓  Vortex Nozzle System. Patent-pending airflow design for finer atomisation at lower pressure: smoother gradients, less overspray, cleaner edges.

✓  360 Quick-Fit air cap. Faster setup and cleaning, less dried paint build-up, needle protection built in.

✓  Redesigned teardrop trigger. Wider surface and longer travel for a smooth dual-action feel through long sessions.

About the Aventus

The Aventus is Gaahleri’s ground-up redesign of the modern airbrush. A three-part modular body is CNC-milled from a single block of aerospace-grade aluminium — no welds, no seams — with uninterrupted curves that follow the hand like a good pen. The finish is a 220-mesh anodised aluminium in this Verdant Ember green: a satin-matte surface that resists corrosion and holds its looks.

At the heart is the patent-pending Vortex Nozzle System, which spins air into a controlled spiral before it leaves the nozzle. The result is finer atomisation at lower pressure, smoother blends and noticeably less overspray. The teardrop trigger gives a smooth, near-instant dual-action response, and the 360 Quick-Fit air cap speeds up setup and cleaning.

It ships dual-calibre: a 0.2 mm setup for fine lines, panel shading and weathering, and a 0.4 mm setup for base coats and broader coverage — one tool across the whole range of work.

Specifications

What’s in the box

▸  Aventus airbrush body

▸  Wide round air cap

▸  0.4 mm nozzle cap + nozzle + needle

▸  360 Quick-Fit air cap

▸  0.2 mm nozzle cap + nozzle

▸  1/10 oz Ultra Mirror-Level gravity cup

▸  1/5 oz Ultra Mirror-Level gravity cup

▸  Male quick-disconnect fitting

Who it’s for

Suited to miniature and figure painting, scale modelling, Gunpla and general hobby airbrushing. It connects to any standard 1/8" airbrush hose, so it drops straight into most existing compressor setups. Capable enough for professional work, while the smooth trigger and predictable spray also make it friendly for a motivated newcomer.

Getting the most from it

◆  Work around 15–25 PSI for detail and 20–30 PSI for coverage — start low and bring the pressure up slowly until the spray feels stable.

◆  Keep the 0.2 mm setup in for lines, shading and weathering; switch to 0.4 mm for primer and base coats.

◆  Back-flush between colours and give it a thorough clean at the end of each session — it’s the single biggest thing for consistent spray.

◆  Remove and refit the needle gently — never force it.

◆  Thin water-based and acrylic paints to roughly milk consistency for the cleanest results through the 0.2 mm.