AK9009 is made for thicker non-metallic stock: plastic, PVC, resin and ABS parts or rods below 4 mm. Its plier format places the cutting head directly above the grips for controlled bench work on those materials. The limit is as important as the capacity: AK expressly instructs users not to cut metal parts with this tool.
A spring return reopens the plier after each cut.
The ergonomic grips are covered with orange, non-slip vinyl foam.
The cut is clean and precise, with no touch-up needed afterwards.
03
Notes · Q & A
What is single-edge (flush) vs double-edge cutting on sprue nippers?+
Single-edge, or flush, cutters have one flat face and one bevelled blade, leaving a near-clean cut on the part side. Double-edge cutters bevel both sides and pinch, leaving a small nub you then trim. For plastic kits, flush is worth it.
Can I use hobby sprue cutters on metal miniatures or wire?+
No. Fine flush cutters are ground for soft plastic and resin; metal minis, brass rod and staples will chip or roll the edge. Keep a separate, more robust pair for metal and save your good cutters for plastic.
How do I cut parts off the sprue without stress marks?+
Cut twice. Leave a little sprue on the first pass, then trim flush away from the part, blade flat to the surface. Cutting hard against the part whitens and dents the plastic as the blades pinch it.
Why has my cutter stopped cutting cleanly?+
Usually a nicked or misaligned edge from cutting something too hard, or dried glue in the joint. Wipe the blades, add a drop of oil to the pivot, and only cut material the tool is rated for. A chipped flush edge cannot be honed back.
04
Notes · Logistics
Shipping
Orders placed before 3pm (Mon–Fri) are dispatched the same day. UK delivery is by Royal Mail 24 Tracked. Free UK delivery on orders over £70. International delivery available via Royal Mail International Tracked or courier.
Returns
If you're not happy with your purchase, contact us within 30 days for a full refund or exchange. Items must be unused and in original packaging.